Slider Errors


R5211-01 & R5211-02

R5211-01 & R5211-02 R5211-01 & R5211-02
Beep Pattern SL2000B, SL2200B, GPX-SL25, LPA13, LPS Blink Pattern SL2000B, SL2200B, GPX-SL25, LPA13, LPS
1 beep every 2 sec Master Limit Switch (both have closed circuit at same time) 1 blink every 2 sec Cycle Input Short
Remove wire(s) from CYCLE to resolve
2 beeps every 2 sec Secondary Limit Switch (both have closed circuit at same time) 2 blinks every 2 sec Safety Input Short
Remove wire(s) from SAFETY to resolve
5 beeps every 2 sec Current Sensing Fault / Faulty Board 3 blinks every 2 sec Exit Input Short
Remove wire(s) from EXIT to resolve
1 beep then 2 beeps every 2 sec Master Terminal Red/Blk Short if motor test pass
or Motor Short if motor test fails
4 blinks every 2 sec Shadow Input Short
Remove wire(s) from SHADOW to resolve
1 beeps then 3 beeps every 2 sec Secondary Terminal Red/Blk Short if motor test pass
or Motor Short if motor test fails
5 blinks every 2 sec Close Edge Input Short
Remove wire(s) from CLOSE to resolve
1 beep every 10-20 sec 6 blinks every 2 sec Open Edge Input Short
Remove wire(s) from OPEN to resolve
Continuous Uninterrupted Alarm, No Ops COUNT ERROR or Double Obstruction
Gate Stops and Reverses COUNT ERROR or Obstruction
Power Up Beeps or Clicks upon Activation, No Ops

AQ251

AQ251
Visual Error SL2000B, SL2200B, GPX-SL25, LPA13, LPS, SL2000, SL1000
Gate Stops and Reverses Obstruction
Clicks upon Activation, No Ops
Clicks upon Activation, No Ops Motor Short or Open Motor Circuit
Clicks upon Activation, No Ops Gate Binding, Motor pulling too many amps
Red Status LED is off or blinking, No Ops
Red Status LED Blinking but battery is already fully charged Accessory Input Short
Remove wire(s) from GRN, ORG, BLU, & WHT to resolve